Skip to content
← Engineering notes

Building a hardware product in India

BLE, Wi-Fi, LoRa or LTE Cat-1 for a product sold in India

14 November 2026 · Shalaka engineering team

The radio decision shapes the battery, the BoM, the approvals and the monthly running cost of a connected product. It is also one of the hardest decisions to reverse after the first board run. These are the questions we ask before choosing.

Where does the data go first?

A phone nearby. BLE. The phone app does the setup and passes data to the cloud. Lowest power, and almost every phone supports it. Range indoors is usually a room or two.

A building with Wi-Fi. Wi-Fi is cheap on the BoM and needs no gateway, but it is power-hungry, and someone has to enter the network password. In factories, expect enterprise Wi-Fi with certificates, guest networks that block devices, and IT teams who would rather not have your device on their network at all.

A site with no network, or a wide area. LoRa, in the 865 to 867 MHz band that is licence-exempt in India. Long range at very low data rates, years on a battery for small readings, but you need a gateway (yours or a network operator’s), and it will not carry images or frequent updates.

Anywhere with mobile coverage. LTE Cat-1, which keeps working as 2G and 3G networks shrink, and is easier on power and price than full LTE. It needs a SIM, a data plan and good coverage where the device is installed. Factory floors and basements can be dead zones even in cities.

The questions that usually decide it

  • How much data, how often? A reading every 15 minutes and a camera image every minute need different radios.
  • Battery or mains? If battery, what life does the customer expect?
  • Who installs it, and who fixes it when the network changes?
  • What does connectivity cost per device per month, and who pays it?
  • Do you need to send commands to the device, or only receive data?

Approvals

Any product with a radio sold in India needs the relevant wireless approval (WPC Equipment Type Approval), and cellular products may also fall under TEC certification. Using a pre-certified module helps, but the finished product still has to be covered. The rules change, so check the current requirements with a test lab early. Do not leave it until the product is ready to ship.

Two radios are sometimes right

BLE for setup from a phone, plus Wi-Fi or Cat-1 for data, is a common pair. It costs some BoM and firmware effort and saves a lot of support calls.


If you are choosing a radio for a new product, book a discovery call. It is the decision we would most like to get right with you on paper.

Tell us what you are building.

A 30-minute discovery call with an engineer. We reply within 48 hours.

Book a discovery call