A machine alarm usually reaches maintenance as a phone call or a shouted message. The technician walks over, asks what it was doing, and starts looking. Ten minutes go before the first measurement. A ticket created from the alarm itself can carry the answers with it.
Start from the alarm, not from every alarm
A PLC or controller can raise dozens of alarms a day, and most are warnings. If each one creates a ticket, the list fills with noise and people stop reading it. Decide first which alarms need a person: a trip, a repeated warning, a value past a hard limit. Handle the rest as counts on a dashboard.
Then add the usual protections:
- Debounce. An alarm that flickers on and off for a minute is one event.
- De-duplicate. While a ticket is open for that machine and alarm, a new occurrence adds a line to it, not a second ticket.
- Hold for a short time before escalating, so a self-clearing fault does not wake anyone.
What to attach
The value of the ticket is in what travels with it. For a machine on Modbus, OPC UA or MQTT, the app can fetch and attach:
- The alarm code and its plain-language meaning from the machine’s manual.
- The last readings before the alarm: motor current, temperature, pressure, vibration, whichever the machine reports. A trace of the 10 or 15 minutes before the event is usually enough.
- Run hours and the time since the last service.
- The last few tickets for this machine and alarm, with what fixed them.
That last item does most of the work. A technician who sees that the same bearing alarm closed three times with a grease top-up knows where to start.
Assignment and follow-up
Route by machine area or skill, and send the ticket by app or WhatsApp with the machine name first. Ask for a closing note with a cause from a short list and a free text line. Without a cause, the history stays unsearchable.
Escalate when a ticket stays unacknowledged for a set time, and show the open count on the shop floor screen.
Where this stops
An alarm ticket is only as good as the signals the machine exposes. Older machines with no communication port give you a stack light and little else, and a current sensor or a retrofit gateway is needed to see anything. Attached history also helps a person decide, but it does not diagnose. The technician still has to open the machine.
If your alarms still travel by phone call, our micro-apps for electronics and manufacturing turn them into tickets, so book a discovery call.
